Full size SAM GPS - MRO10037
This is the next-generation of the uBlox SAM GPS module with the IST8308 compass. The mRo SAM GPS V2.0 is based on the old and now retired mRo mini SAM. The main difference is that it uses an ideal ground plane of 40mm x 40mm as recommended by uBlox. This makes it a little heavier at 10.3 grams versus 7.6 grams, but it also gives you an increase from ~22 dB-Hz to ~34dB-Hz, which is a lot of gain for just 2.7 grams! We saved some weight with a new generation, smaller rechargeable coin battery and a thinner PCB.
mRo SAM GPS + IST8308 Mag (Full Size) Supports: Ardupilot
|mRo SAM GPS + IST8308 Mag (Full Size) MRO10037
|40mm x 40mm
|USA (GPS), Russia(GLONASS) and Europe (Galileo). China can be enabled (BeiDou).
|Compatibility* *See full compatibility chart for supported flighstack versions
|Minimum and Maximum Operating Temperature
|-20 ~ 80 °C
|40mm x 40mm x 11.5mm
|9 grams (.32 oz)
|-6-Pins JST-GH-Auxiliary Port I2c
|1x mRo uGPS ublox Sam M8Q.
1x 6-Pins JST-GH to 6-Pins JST-GH – MRC0206
1x 6-Pins JST-GH to 6 Separate 2.54mm Females – MRC0202 (For project versatility)
|*PPS/GND signal pads
*Standard JST-GH (GPS and I2C)
*Standard 30.5mm x 30.5mm mounting holes (1.2″ x 1.2″)
mRo SAM GPS + IST8308 Mag (Full Size) MRO10037 is compatible with the following firmware:
- Arducopter 4.x
- ArduPlane 4.x
- ArduRover 4.x
V1.8 (and further versions)
All connectors follow the Dronecode connector standard. Unless noted otherwise, all connectors are JST-GH.
|I2C_SCL (pull-up on autopilot)
|I2C_SDA (pull-up on autopilot)